Summa OPOS

General information about OPOS Barcode: Sending an OPOS job from the Editor to Printer and an OPOS cutter will result in two unique jobs, one in the printer and one in the cutter queue. The print job contains a unique barcode and the cutter job also has this barcode information inside. The cutter job will […]

Read More

Roland Printers not printing

A problem that can occur when you want to print to a Roland printer is that the printer Beeps and does not start printing. Possible cause When the ink set selected in the driver settings of the RIP does not correspond with the ink set selected in the Roland Printer the job is rejected by the Printer […]

Read More

Roland LEC, LEJ, LEF

General Although this info is first written concerning the LEC 330, the described info is also very usefull information for other LEC, LEJ and LEF printers. Available ink sets The Roland LEC 330 is available with one of the following ink sets. CMYK + White + Varnish CMYK + 2xWhite CMYK + 2xVarnish Inks that […]

Read More

Inca Multi Layer Printing

For the Inca OnSet S40 and Q40 multi layer printing is available in the driver. Allowing to print Color and White separately using different modes/speeds and densities for color and the white layer. Also it support Color-White-Color using several strategies.

Read More

Inca Installation

The installation of an Inca printer consists of 2 important steps: Copy the currently used IncaDeviceDetails .txt into the RIP installation Install and set-up PrintAgent IncaDeviceDetails The IncaDeviceDetails.txt is used to define the print modes used for the Inca. The installation contains template files for each model that is copied to <data directory>/Inca Setup/<Inca model […]

Read More

HandTop

Below are the configuration and set-up instruction for HandTop printers. Workflow There are 2 ways of connecting the HandTop printer. The first way is the send print files to the HandTop TOPJet application, where you can pickup the file and get it printed. The second is by installing PrintStation on the computer that controls the […]

Read More

GTK Support

This document is not meant as a user guide but as a help for Support in case an installation also contains a Zünd with GTK. there are a couple of programs that could be used to cut/produce on a Zund. The newer versions Zünd G3 most of the time use ZCC (Zünd Cut Center) expected […]

Read More

Epson Control Dashboard Installation/configuration

The Epson Control Dashboard contains a Status Interface, ‘.emx’ profiles (these can be imported directly into Calibrator and are converted automatically to ‘.pmms’) and media settings (which can be copied directly to the printer from the interface).   Below you can find the steps to install/configure the Epson Control Dashboard: Make sure the printer is […]

Read More

Epson 4000 – Allowed Media per Tray

The paper path requirements depend on the media you use. This error occurs when paper is loaded using the wrong paper path. Choose the correct paper path for the media you are using: Paper Tray Epson Premium Semigloss Photo Paper Epson Premium Luster Photo Paper Epson New Photo Quality Ink Jet Paper Epson Proofing Paper […]

Read More